List Archives >
Mathcad List Archive >
Archive by date >
This Month By Date >
This Month By Topic
[mathcad] RE: Rounding up/down error
| [mathcad] RE: Rounding up/down error |
|
Author: Richard Jackson
Posted: Wed, 16 Jul 2003 10:12:07 -0400
|
Except that it doesn't give you a non-rounded (i.e. truncated) figure. It
gives you either a truncated or a rounded figure, depending on the
number. I agree with those that view this as a problem that should get
fixed. I would prefer that it displays a rounded number, but I could live
with a truncated one. Maybe. A mixture of the two is not acceptable
though.
Richard
On 16 Jul 2003 at 14:56, Fletcher, Ian wrote:
> All,
>
> I would regard this result as getting what I had asked for. A calculation
> using the result displayed without rounding would use the non-rounded figure
> as you would require.
>
> Regards,
>
> Ian Fletcher.
---
The Mathcad List - Discussion, Support & News
Contributions: />
Hosted by: Adept Scientific http://www.adeptscience.com
List Archive: http://lists.adeptscience.co.uk/
---
Would you like this to come to a different email address?
---
Simply leave the mailing list (see below) and re-join by
sending a blank email from the new address to:
or
---
If you do not want to be on the Mathcad list, simply send a
blank email (no subject or message needed) to:
/>
|
[View Complete Thread]
Previous by date: [mathcad] RE: Rounding up/down error, Fletcher, Ian
Next by date: [mathcad] Re: Rounding up/down error, Chris Whitford
Previous thread: [mathcad] [mathcad]Re: Rounding up/down error, Markos E Psarros
Next thread: [mathcad] Re: Rounding up/down error, Chris Whitford
|
RSS Feeds
and Mathcad Prime 1.0